All checklistsChecklist
Closed-circuit breathing apparatus pre-use check
Before each wear and at the team readiness check: oxygen, absorber, leak tests, valves, warning signal and mask of one closed-circuit set. A fail makes the set unserviceable.
- Items
- 13, in 6 sections
Set
- Set ID or serialNoteType the number on the label or tag. Stands in for a scan.
- Cooling or ice fittedPass or failWhere the set uses cooling. Remove this item where it does not apply.
- Electronic monitor displayPhotoPhotograph the display after the check. Remove this item for a set without an electronic monitor.
Oxygen
- Oxygen cylinder pressureReading against your limit · out of service if it fails · photo every timeRead the set’s gauge and photograph it. Set your minimum from the maker’s manual and your procedure.
Absorber
- CO2 absorber fittedPass or fail · out of service if it fails
- Absorber use-by or fill dateExpiry dateThe date on the canister or the fill label. Warns 30 days before.
- Tests or wears since the absorber was filledReading against your limitSet your maximum from the maker’s limit.
Tests
- High pressure leak test passedPass or fail · out of service if it fails
- Low pressure leak test passedPass or fail · out of service if it fails
- Bypass and lung demand valve workPass or fail · out of service if it fails
- Warning signal sounds at the set pressurePass or fail · out of service if it failsThe pressure the maker sets for the warning.
Mask
- Mask, straps and seals in good conditionPass or fail
Result
- Set resultChoose one · out of service if it fails
Checked by ______________________ Date and time ______________ Unit ______________
No limit is shown here on purpose: set each from the maker’s manual or your own procedure. A starting point: change the items to match your procedure before you rely on them.
Send us your own version of this check
We will build it into Escudo Mining with your items and your rule pack, and show it running on a phone underground with no signal.
Or email us: info@escudoready.com