Skip to content
Book a demo
Suits
Lower-deck container/pallet loader (3.5 t to 7 t)
When
Before use
Items
53, in 30 sections

Identity

  1. Scan the START tag; confirm the GSE ID plate matches the asset on screenScan or type the code · out of service if it fails
  2. Airside vehicle permit / airside registration label present, legible and in dateDate · out of service if it fails

Walk-around

  1. Walk around the whole unit: no new body damage, cracks, sharp edges or loose panelsPass, fail or not applicable · photo every time
  2. No fluid leaks under the unit (oil, coolant, hydraulic, fuel, electrolyte)Pass, fail or not applicable · out of service if it fails · photo every time

Tyres & wheels

  1. Tyres: no cuts, bulges, exposed cord or flats; tread adequate; solid tyres not chunkedPass, fail or not applicable · out of service if it fails
  2. Wheel nuts all present; no rust trails or movement on nut indicatorsPass, fail or not applicable · out of service if it fails
  3. Tyre pressures (pneumatic only) within OEM range (limits set per asset)Reading against your limit

Fluids

  1. Engine oil level between marksPass, fail or not applicable
  2. Coolant level at or above minimum (check cold)Pass, fail or not applicable
  3. Hydraulic oil level within sight-glass rangePass, fail or not applicable
  4. Fuel level / battery state of charge sufficient for the shiftReading against your limit
  5. AdBlue/DEF level above warning (diesel with SCR)Pass, fail or not applicable

Electrical

  1. Battery secure, terminals covered, no swelling or damage; charging lead and plug undamaged and disconnected before movingPass, fail or not applicable · out of service if it fails
  2. No warning lamps or active fault codes after start-upPass, fail or not applicable

Lights

  1. Headlights, tail, brake and indicator lights workPass, fail or not applicable
  2. Flashing/rotating amber beacon(s) work and visible 360°Pass, fail or not applicable · out of service if it fails · photo every time

Audible

  1. Horn worksPass, fail or not applicable
  2. Reversing alarm (tonal or broadband) sounds when reverse selectedPass, fail or not applicable · out of service if it fails

Vision

  1. Mirrors present, secure, uncracked, adjusted; camera image clearPass, fail or not applicable

Brakes

  1. Service brake test at walking pace: stops straight and promptlyPass, fail or not applicable · out of service if it fails
  2. Parking brake holds the unit (slope or drive-against test per OEM)Pass, fail or not applicable · out of service if it fails

Steering

  1. Steering free, no excessive playPass, fail or not applicable · out of service if it fails

Cab

  1. Seat secure; seat belt latches and retracts; operator presence switch worksPass, fail or not applicable · out of service if it fails

Controls

  1. Drive and work controls return to neutral; labels legible; interlocks (e.g. drive inhibit when raised/stabilised, neutral-start) workPass, fail or not applicable · out of service if it fails
  2. Emergency stop(s) cut drive/hydraulics; reset correctlyPass, fail or not applicable · out of service if it fails

Fire

  1. Extinguisher present in bracket, pin and seal intact, gauge in green, service tag in datePass, fail or not applicable · out of service if it fails
  2. Extinguisher service date (from tag)Date · out of service if it fails

Aircraft protection

  1. Proximity sensors / auto slow-down / anti-collision system passes self-test or test approach (where fitted)Pass, fail or not applicable · out of service if it fails

Markings

  1. Reflective tape and conspicuity markings present and clean; GSE ID number visible both sidesPass, fail or not applicable

Speed

  1. Speed limiter operating (max speed not exceeded in test, or limiter seal intact)Pass, fail or not applicable · out of service if it fails

FOD

  1. Cab, decks and trays free of loose items that could fall or blow onto the apronPass, fail or not applicable
  2. Cleanliness: windows clean, steps not slippery, no rubbishPass, fail or not applicable

Documents

  1. Logbook / operator card and emergency contacts present; open defects reviewed in appPass, fail or not applicable

Maintenance

  1. Hour meter / odometer readingReading against your limit
  2. Next service due (date or hours) not exceeded: computed from I35 and workshop dataPass or fail
  3. Annual / statutory inspection label in dateDate · out of service if it fails

Exhaust

  1. No excessive smoke; exhaust and spark arrestor (where required) intactPass, fail or not applicable

Radio

  1. Two-way / airport radio works (where fitted or required)Pass, fail or not applicable

Bridge platform

  1. Front (bridge) platform raises/lowers smoothly; level indication worksPass, fail or not applicable · out of service if it fails
  2. Bridge platform bumpers/aircraft contact pads intactPass, fail or not applicable · out of service if it fails · photo every time
  3. Bridge side guard rails/railing raise and lock; operator platform guard rails intactPass, fail or not applicable · out of service if it fails

Main platform

  1. Main (rear) platform raises to bridge height and holds; no creepPass, fail or not applicable · out of service if it fails
  2. Scissor/lift chains or cylinders: no leaks, cracks, damaged chainsPass, fail or not applicable · out of service if it fails
  3. Safety props/maintenance struts stowed and presentPass, fail or not applicable · out of service if it fails

Conveyor

  1. Powered rollers/castor deck run in all directions; side-shift worksPass, fail or not applicable
  2. ULD stops raise and hold at both platformsPass, fail or not applicable · out of service if it fails

Interlocks

  1. Drive inhibited while platforms raised or stabilisers downPass, fail or not applicable · out of service if it fails

Stabilisers

  1. Stabilisers deploy and retract; pads intactPass, fail or not applicable · out of service if it fails

Aircraft interface

  1. Auto-level / aircraft-following function works (where fitted)Pass, fail or not applicable · out of service if it fails
  2. Approach slow-down / proximity sensors workPass, fail or not applicable · out of service if it fails

Emergency

  1. Emergency lowering (manual valve / hand pump) accessible and markedPass, fail or not applicable · out of service if it fails

Load

  1. Capacity plate legible; LT certificate in dateDate · out of service if it fails

Sign-off

  1. Operator declares the unit fit for use, or unfitChoose one · out of service if it fails

Checked by ______________________   Date and time ______________   Unit ______________

No limit is shown here on purpose: set each from the maker’s manual or your own procedure. A starting point: change the items to match your procedure before you rely on them.

How it differs from the towbarless tractor pre-use check

39 of its 53 items are the same on both. This one adds front (bridge) platform raises/lowers smoothly; level indication works, bridge platform bumpers/aircraft contact pads intact, bridge side guard rails/railing raise and lock; operator platform guard rails intact, main (rear) platform raises to bridge height and holds; no creep, scissor/lift chains or cylinders: no leaks, cracks, damaged chains and 9 more. It leaves out brake test unloaded, dual cab / reversible controls switch over correctly (where fitted), bumpers / rubbing strips / aircraft-contact pads present, secure, not split or compressed flat, nose-wheel cradle/pick-up plate free of cracks, deformation and debris, clamp arms/gates and hold-down device move through full range and lock and 9 more.

What this checklist asks for

Takes the unit out of service

As the starter is set, a fail on any of these takes the unit out of service until the defect is cleared. You can change what any item does.

  • Scan the START tag; confirm the GSE ID plate matches the asset on screen
  • Airside vehicle permit / airside registration label present, legible and in date
  • No fluid leaks under the unit (oil, coolant, hydraulic, fuel, electrolyte)
  • Tyres: no cuts, bulges, exposed cord or flats; tread adequate; solid tyres not chunked
  • Wheel nuts all present; no rust trails or movement on nut indicators
  • Battery secure, terminals covered, no swelling or damage; charging lead and plug undamaged and disconnected before moving
  • Flashing/rotating amber beacon(s) work and visible 360°
  • Reversing alarm (tonal or broadband) sounds when reverse selected
  • Service brake test at walking pace: stops straight and promptly
  • Parking brake holds the unit (slope or drive-against test per OEM)
  • Steering free, no excessive play
  • Seat secure; seat belt latches and retracts; operator presence switch works
  • Drive and work controls return to neutral; labels legible; interlocks (e.g. drive inhibit when raised/stabilised, neutral-start) work
  • Emergency stop(s) cut drive/hydraulics; reset correctly
  • Extinguisher present in bracket, pin and seal intact, gauge in green, service tag in date
  • Extinguisher service date (from tag)
  • Proximity sensors / auto slow-down / anti-collision system passes self-test or test approach (where fitted)
  • Speed limiter operating (max speed not exceeded in test, or limiter seal intact)
  • Annual / statutory inspection label in date
  • Front (bridge) platform raises/lowers smoothly; level indication works
  • Bridge platform bumpers/aircraft contact pads intact
  • Bridge side guard rails/railing raise and lock; operator platform guard rails intact
  • Main (rear) platform raises to bridge height and holds; no creep
  • Scissor/lift chains or cylinders: no leaks, cracks, damaged chains
  • Safety props/maintenance struts stowed and present
  • ULD stops raise and hold at both platforms
  • Drive inhibited while platforms raised or stabilisers down
  • Stabilisers deploy and retract; pads intact
  • Auto-level / aircraft-following function works (where fitted)
  • Approach slow-down / proximity sensors work
  • Emergency lowering (manual valve / hand pump) accessible and marked
  • Capacity plate legible; LT certificate in date
  • Operator declares the unit fit for use, or unfit

Takes a number against your limit

The limit is yours to set; until you do, the number is kept with no pass or fail.

  • Tyre pressures (pneumatic only) within OEM range (limits set per asset)
  • Fuel level / battery state of charge sufficient for the shift
  • Hour meter / odometer reading

Needs a photo every time

Taken live on the phone and kept with the answer.

  • Walk around the whole unit: no new body damage, cracks, sharp edges or loose panels
  • No fluid leaks under the unit (oil, coolant, hydraulic, fuel, electrolyte)
  • Flashing/rotating amber beacon(s) work and visible 360°
  • Bridge platform bumpers/aircraft contact pads intact

Questions about this checklist

What does the lower-deck container/pallet loader (3.5 t to 7 t) pre-use check cover?

53 items in 30 sections: identity, walk-around, tyres & wheels, fluids, electrical, lights and 24 more.

What happens when an item fails in Escudo Aviation?

As the starter is set: 33 items take the unit out of service when they fail; the rest are recorded. You can change what any item does. A failure asks for a photo on 24 items, and the defect goes to the people who fix it.

Does the lower-deck container/pallet loader (3.5 t to 7 t) pre-use check come with limits?

No. 3 items take a number against a limit (tyre pressures (pneumatic only) within OEM range (limits set per asset), fuel level / battery state of charge sufficient for the shift and hour meter / odometer reading), and each limit is yours to set from the maker’s manual or your own procedure. Until you set one, the number is still recorded.

Run it on the phone instead of paper

Open it from the unit’s tag, with or without signal. A failed item becomes a defect with a photo and sets the status as your template says.

Send us your own version of this check

We load your vehicles, zones and the templates you choose, you validate them in your own words, and your crews start checking. Tell us about your airport.